Search
Generic filters
Exact matches only
  1. Connect GigaMesh to a power outlet.
  2. When the LED is flashing red, you can pair the GigaMesh with the GigaSpire. Press and hold the WPS buttons on the GigaMesh and then on the GigaSpire for 3 seconds each (less than 30 seconds apart). The LEDs flash green while attempting to pair.
  3. Use the solid green LED indicator (displays for 60 seconds at end of pairing cycle) to determine ideal location for the GigaMesh. If necessary, relocate it to a more ideal distance from the GigaSpire and confirm successful pairing after the GigaMesh reboots (repeating steps 2–3 as needed).-Once successful pairing is complete, the GigaSpire and GigaMesh LEDs will both show a solid cyan (light blue) color. It may take several minutes to reach this state.

For additional help or support contact Wizards Technical Support at (877) 457-9669.

Was this article helpful?

Print Friendly, PDF & Email

Related Articles