The remote control can be programmed by pressing in a 3-digit code number that corresponds to a particular manufacturer and brand of Audio/Video component. The 3-digit code numbers are listed in the Set-up Code Tables. (Code tables for your Palamino4 Remote follow these instructions).
Turn on the A/V component you wish to program. (TV, VCR, DVD or AUX)
Press the COMPONENT (TV, VCR, DVD or AUX) button to be programmed and the OKbutton simultaneously for 3 seconds. The selected component LED light will turn on indicating the component is ready to be programmed. -If you do not begin entering code numbers within 20 seconds, the component LED light will turn off and exit set-up mode and you will need to start over.
Point the remote control toward the selected component and enter the 3-digit code number assigned to your brand from the code tables. -The component will turn off when the correct 3-digit code number has been entered. You can verify you have selected the correct code by pressing the Power button. The component should turn on or off. If there is more than one 3-digit code number listed for your brand, try one code number at a time until your component turns off.
Store the 3-digit code number by pressing the same COMPONENT(TV, VCR, DVDor AUX) button once again. The component LED will blink twice to con rm that the code has been stored.
-Try all the functions on the remote control. If any of the functions do not work as they should, repeat from Step 2 using the next 3-digit code number from the same brand list.
Auto Search Method
If the 3-digit code numbers assigned to your brand do not turn off your component or the code tables do not list your brand, you can use the Auto Search Method to find the correct 3-digit code number for your component by performing the following steps:
Turn on the component you wish to operate.
Press the COMPONENT (TV,VCR, DVD or AUX) button to be programmed and the OK button simultaneously for 3 seconds. The component LED will turn on.
Press the CH+ or CH- button one step at a time or keep it pressed. The remote will emit a series of Power ON/OFF commands. Release the CH+ or CH- button as soon as the component turns off.
Press the same COMPONENT (TV,VCR, DVD or AUX) button to store the code. The component LED light will blink twice to con rm that the code has been stored.
-If you do not press either the CH+ or CH button within 20 seconds, the component button LED light will turn off and exit set-up mode and you will need to start over. You can verify that you selected the correct code by pressing the Power button again. The component should either turn on or off.